Using CodeWarrior with Axiom HC11 boards
========================================

Following is a Quick Start for using the CodeWarrior development software with Axiom HC11 boards.  The instructions below use the files in this directory.

Preparing your hardware:

1. Connect the serial cable and power to your CME11-EVBU board.
2. Install MODA, MODB and WRITE_EN jumpers.
3. Use the AxIDE software to program the file: hc11evbu.s19 into external EEPROM.
4. Remove MODA, MODB and WRITE_EN jumpers and press RESET on the board.
5. The letter I should display on the terminal, indicating success.  
6. EXIT the AxIDE program.

Create an application:

 1. Launch the CodeWarrior IDE.
 2. Select File > New.
 3. Select the HC11 Stationery and give your project a name and set the directory location.  Click OK.
 4. Choose HC11 SMONITOR by clicking its plus (+) sign.
 5. Choose CME11E9-EVBU then Click OK.
 6. This creates a sample program in the project window.
 7. Select Project > Make to compile your project.
 8. Select Project > Enable Debugger.
 9. Select Project > Debug to bring up the debug window.
10. The sample program is loaded into RAM so you can execute, set break points, single step, etc.

For more information, see:
 - the text files included in the sample project
 - the Axiom owners manual for your board
 - the CodeWarrior software documention 
 - the Metrowerks web site: http://www.metrowerks.com/
 - the Axiom web site: http://www.axman.com/